MTM Series Trapezium Mill
Raymond mill is ever one classic powder grinding machine in the past. And most of modern mill are from it and MTM series milling machine is the most successful one. It optimized the inner structure and lots of core devices. Such as, the new supercharging device can greatly increase production capacity. And separated ploughs are easy to be replaced, both the spare parts cost and breakdown time are obviously reduced. According to hundreds of customers’ feedback, the MTM series grinding mills are quite good at produce 60-325mesh powders. Through word-of-mouth, this milling machine is quite hot in many countries.
Applications: Calcium carbonate crushing processing, gypsum crushing processing, power plant desulfurization, non-metallic ore pulverizing, pulverized coal preparation.
Input Size: 0-50 mm Output Size: 30-325 mesh Capacity: 3 - 22 t/h
Learn More About MTM Series Trapezium Mill
1. Cost advantage
After the grinding roller and rings are worn to a certain degree, by adjusting the length of the compression spring, can a constant grinding pressure be maintained between the grinding roller and the grinding rings, which increases the utilization rate of the roller ring, saves the material costs and the production is kept stable.
2. Creative grinding roller and ring
The grinding roller assemblies are connected by means of the horizontal tie rods and springs, with the radial force applied to protect the main shaft and bearings against the impact from large-sized materials in the grinding chamber, so as to prolong the service life of the equipment.
3. High efficient balancing and pressurizing spring
The main mill and powder classifier are combined by braid connection. The damping springs and sealing tapes are used to reduce the vibration and noise and also avoid resonance.
4. Environmental protection
A variety of de-dusting equipments are available, with the emission standard higher than the national standard.
Working Principle
The host drives the central shaft running (Fig. 3) by the gear box. The upper end of the shaft is connected with a wobbler spindle and the grinding roller is suspended under the wobble spindle by a cross arm shaft and forms a swinging point. The grinding roller runs along with the central shaft of the whole machine, and also rotates by friction with the grinding ring. A perching knife system is installed under the wobble spindle and feeds the material into the gap between the grinding roller and ring for pressing and grinding with the grinding roller during rotation. (Fig. 5) Air flow will bring minor powder into the powder concentrator upon entry into the grinding gravity from the bottom of the grinding ring. Coarse materials fall down and are reground; and fine powder goes into the powder collector along with the air flow and is discharged as the finished product through the powder discharge tube.
